Enterprise Commercial Locksmith Services You Can Rely On

Commercial locksmith work in Enterprise is mostly about doors that open, close and lock the way they should every single business day. We repair and replace closers, panic bars, storefront locks and lever handles on site, and we also handle rekeying and business lockouts.

Most of this hardware work can be completed during a single visit from a fully stocked service van. If the job is really about who holds which keys, see our master key systems page.

• Door closersA closer that slams the door or fails to latch it gets adjusted or replaced on the spot.
• Exit devicesPanic bars are repaired so people can leave quickly while the door still locks behind them.
• Storefront locksNarrow stile locks and cylinders on aluminum glass doors are repaired or replaced on site.
• Lever handlesCommercial levers are easier to operate than round knobs and are common on public entrances.

Commercial Door Hardware We Service

Most business doors in Enterprise share the same few components, and any one of them can stop the whole door from working.

• ClosersWe adjust the closing speed and latch speed so the door shuts completely without slamming, or replace a closer that leaks hydraulic fluid.
• Exit devicesWe repair push bars that stick, fail to latch or allow the door to swing open from the outside.
• Storefront cylinders and locksAluminum glass doors use narrow locks, and we carry the common replacement parts to repair or replace them.
• Levers and knobsWe exchange worn knobs for commercial levers that hold up to heavy daily traffic from customers and employees.
• Strikes and framesA bent strike or a sagging door prevents the latch from catching, so we realign the hardware or replace it.

Door Problems Enterprise Businesses Call About

Most calls begin with a door that misbehaves a little for several weeks before it finally fails completely.

• The front door will not close on its own.We inspect the closer and the hinges, then adjust or replace whatever is holding the door open.
• Our back door panic bar sticks.We clean, adjust or rebuild the exit device, and we replace it entirely if the internal parts are worn out.
• We have to lift the glass door to lock it.We examine the pivots, the lock and the strike, then correct whichever component has dropped out of alignment.
• The handle came loose in someone's hand.We tighten or replace the lever and inspect the lock body behind it for additional damage.

How a Door Hardware Repair Goes

1. 1

   Describe the door

   Tell us what the door is doing, and send a photo if possible so we bring the correct replacement parts.

2. 2

   Inspect on site

   We check the closer, the lock, the strike and the hinges to identify the actual cause.

3. 3

   Quote the fix

   You hear the complete price for the repair before we touch any of the hardware.

4. 4

   Repair and test

   We complete the repair and cycle the door several times so it closes and latches reliably.

What Commercial Door Work Costs in Enterprise

Door hardware is priced by the part and the labor, so a closer adjustment costs far less than a new exit device. Rekeying usually runs about $20 to $50 per lock plus the visit. Planned work comes with a free business estimate, and you receive the price before we begin. Our guide to locksmith costs in Las Vegas lists more typical prices.

Commercial Door Work Around Enterprise

Shopping centers along Blue Diamond Road and Las Vegas Blvd South see heavy foot traffic, and their glass doors and closers wear out faster than most. Offices and warehouses near the 215 and I 15 more often need exit device and back door repairs. Our commercial locksmith services page covers the rest of the valley.

Watch Us Work

Drilling Out an IC Core Cylinder