Henderson Locksmith for Commercial Door Hardware Upgrades

Most commercial door problems in Henderson come down to three parts, which are the closer, the exit device and the lock. We repair or replace worn door hardware on site, so a door that slams, drags or refuses to latch operates correctly again. Many of these repairs take an hour or two per door, depending on the condition of the frame.

Door hardware is one part of our full commercial locksmith service, which also covers rekeying, master key systems and access control.

• Door closersWe adjust, repair or replace closers that slam the door, let it drift or leave it standing open.
• Exit devicesPanic bars that stick or fail to latch are repaired on site or replaced with a new device.
• Storefront locksNarrow aluminum glass doors require special locks and cylinders, and we carry the common sizes.
• Lever handlesWe replace round knobs with commercial levers that are easier for every customer to operate.

Hardware We Repair and Replace

Commercial doors open hundreds of times a day, so the hardware eventually wears out, and these are the pieces we service most often.

• Surface and concealed closersA closer controls how fast the door shuts and whether it latches, and most can be adjusted before they need replacing.
• Panic bars and exit devicesThese let people leave with a single push, and we repair sticking bars, worn latches and dogging that will not hold.
• Storefront deadlocks and cylindersAluminum glass doors use narrow locks that sit inside the frame, and we rekey or replace them to match your other keys.
• Floor pivots and hingesA sagging door often points to a worn pivot or hinge, which also puts extra strain on the lock and the closer.
• Lever setsCommercial levers are designed for heavy daily use and are much easier to operate than traditional knobs.

Door Problems Owners Describe

You do not need to know the name of the part, because once you tell us what the door is doing, we can locate the cause.

• The front door slams so hard it rattles the glass.We adjust the closer speed and the latch, or replace the closer entirely if the hydraulic oil has leaked out.
• The back door drifts open in the wind.We set the closer to finish the swing and confirm that the latch actually meets the strike.
• Customers struggle with the round knob.We install a lever handle that opens with a gentle push of the hand or the elbow.
• Our panic bar has to be slammed to latch.We realign the latch and strike, then replace any worn components inside the exit device.

How a Door Hardware Job Goes

1. 1

   Look at the door

   We open and close the door several times, inspect the frame and identify which component is failing.

2. 2

   Quote each fix

   You hear the price for the repair and for a replacement, so you can choose before we start.

3. 3

   Do the work

   Most closers, levers and exit devices are installed the same day using parts already stocked on the van.

4. 4

   Test the swing

   We cycle the door repeatedly to make sure it closes, latches and locks properly every single time.

What Door Hardware Work Costs in Henderson

The price depends on the part, its grade and how much work the door requires. An adjustment costs far less than a new closer or exit device, so we always check whether a repair will solve the problem first. Estimates for business doors are free, veterans get 10% off new locks, and our price guide lists typical Las Vegas locksmith costs.

Door Hardware for Henderson Storefronts

Glass storefronts are common in the retail centers along Eastern Ave and St Rose Parkway, and their narrow frames require specific locks and pivots. Summer heat thins the fluid in many hydraulic closers, so a door in Green Valley that closed gently in spring can start slamming by July. Our Henderson locksmith page lists everything else we handle around town.

Watch Us Work

Removing a Commercial Lever Lock

Read the Full Guide